Panasonic TX-26LX60A Operating Instructions Manual page 17

Panasonic wide lcd tv operating instructions
Hide thumbs Also See for TX-26LX60A:
Table of Contents

Advertisement

To freely change settings after Auto setup
Select the programme number
and search through the channel
Programme
Channel
number
10
Store
Programme down/up
Search down/up
Return
Exit
Manual tuning
For Manual tuning, using the buttons on the unit
("Tuning mode" on p. 7)
(Press until "Tuning mode" appears)
F
or
(Access Tuning menu)
/
(Press until "Manual tuning" is reached)
F
or
(Access Manual tuning)
/
(Programme, Channel (select), Sound system)
TV/AV
or
(Change programme or start searching
/
channels)
(Store)
STR
-
(Repeat)
Allows you to change the sound system used for a programme channel.
(4.5MHz / 5.5MHz / 6.0MHz / 6.5MHz)
Select the channel you want to adjust
Lets you select the correct transmission standard for the transmission signal being received. (p. 15)
(Auto / PAL / SECAM / NTSC 4.43 / NTSC 3.58)
Select the channel you want to adjust
Normally, select "Auto"
For the small adjustments to the tuning of an individual channel (useful for example when weather conditions are
affecting reception quality of a programme)
Select the channel you want to adjust
To cancel Fine tuning, tune again by Manual tuning
For skipping the programme numbers on which no TV stations are tuned
Select the programme numbers you want to skip
To skip another channel, select the channel number via channel number buttons (if selecting two digits channel,
you must fi rst press the -/-- key then the channel digits).
If you intend to change the skip settings for a number of channels, write the channels' numbers on a piece of
paper before you begin.
select
search
programme
Programme number
(Blinks)
Sound system
(Blinks)
Set this function
OK
Set this function
OK
Set this function
OK
Set "Skip" to "On"
Store
When the desired
channel is found,
press OK to
store.
OK
The programme
number blinks.
STR
F
/
TV/AV
To return to TV
10
4. 5MHz
Manual tuning
-, +
TV / AV
STR
F
STR
Channel
OK
Repeat
and
Note
If a VCR is
connected with
only the RF
cable, select
programme
number "0".
F
: Search
: Move cursor
: To store
: To exit
F
- /
+ /
TV / AV
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tx-32lx60a

Table of Contents