Advertisement
Note OIR of the T3 DFC is similar to that of the T1 or E1 DFC. To see an example of the
output during online insertion and removal of an E1 DFC refer to
Chapter 3, "T1 and E1 Dial
Feature Cards"
Step 8 Loosen the two captive screws that secure the DFC to the chassis until each screw is free
of the chassis. (See
Figure 4-4
and
Figure
4-5.)
Figure 4-4 Loosen the Captive Screws on the Cisco AS5350
Figure 4-5 Loosen the Captive Screws on the Cisco AS5400
Step 9 Grasp the DFC handle with one hand and pull the card toward you until the card slides
free of the chassis. Grasp the ventilated metal cover with your other hand to support and guide
the DFC out of the slot. (See
Figure 4-6
and
Figure
4-7.)
Caution Avoid touching any pins or circuit board components during removal and installation
of the DFC.
Advertisement
