Trouble Shooting - Siemens LC38S953 Series Operating And Installation Manual

Table of Contents

Advertisement

Cleaning, Maintenance and Repair
Oil Collector

Trouble Shooting

Problems
Appliance cannot work.
The motor does not work
and the lamp cannot be
turned on.
The motor works but the
lamp cannot be turned on.
The suction force is not
strong enough.
"E1" shown in screen when
self cleaning is operating.
"E2" shown in screen, fan
can work, discontinuous
beeps and all control
buttons locked when self
cleaning is not operating.
15
When two third of the oil collector is filled up, the oil
collector should be cleaned to avoid any oil spills.
Detach the oil collector according to the figure.
Caution!!!
The cooker hood may cause a fire, if the oil collector
is not cleaned according to the methods mentioned in
the operation instruction.
Caution!!!
Maintenance of the cooker hood should only be done
by qualified technicians.
Refer to the following table for any possible malfunctions
and remedy. If the malfunction is still present, pull out
the plug of the cooker hood and contact our customer
service centre.
Possible cause
Electromagnetism
disturbance.
The plug is not or
improperly inserted or no
power supply.
The lamp is damaged.
Not adjusted to the
maximum fan speed.
Air convection is strong.
Self cleaning function is
defected.
Self cleaning controlling
components is broken.
If one of the following malfunction occurs, please pull
out the electric plug of the cooker hood at once and
contact our customer service centre.
Irregular operating sounds are heard after turned on.
Vibration occurs during the operation.
Smell, smoke or heat release from the cooker hood.
Notes/Remedy
Pull out the plug, Re-insert it
after 1 min.
Make sure the plug is
inserted properly. Ask an
electrician to repair.
Replace the lamp.
Adjust the fan speed to the
maximum rank.
Close the window at one side.
Pull out the plug, Re-insert it
after 1 min.
Pull out the plug, Re-insert it
after 1 min. If this problem can
not be removed, please pull out
the plug and contact Siemens
customer service centre.

Advertisement

Table of Contents
loading

Table of Contents