Table of Contents
Advertisement
Cleaning, Maintenance and Repair
Changing the Fluorescent
Lamp
2
1
1
2
1
2
3
1
2
3
Steps to change the fluorescent lamp:
1. Switch off the extractor hood and pulling out the
main plug or switching off the fuse on the installation
side.
Caution!!!
When switched on, the fluorescent lamp becomes
very hot. Even for some time after the lamp have
been switched off there is still a risk of burns.
2. Using screw driver to disassembly the lamp
assembly.
3. Push down the lamp assembly then take out the
lamp assembly.
4. Disconnect the lamp wire.
5. Removing adhesive tape
6. Push the lamp canopy top panel and disassembly
the lamp cover and lamp canopy top panel.
7. Circumrotating the fluorescent bulb until the
fluorescent bulb can be move out.
8. Replace the fluorescent lamp (conventional
fluorescent lamp , 220 Volt, max. 12Watt ).
Caution!!!
Risk of breakage !
9. Reassemble all parts according contrary sequence.
Note:
If the light does not function, check that the bulbs have
been inserted correctly.
16
Advertisement
Table of Contents
