Print; Notes - MBot Grid II+ Quick Start Manual

MBot Grid II+ 3D Printer QUICK START GUIDE
●PRINT
1. Use the slicing software MPrint to convert model (.stl) into the readable format
(.x3g) for the printer. Then copy the .x3g files to SD card, and insert it to corresponding
port on the machine.
2. Turn the control knob to select [Print] and press to enter. Use the control knob to
choose file and press to enter. Now your 3D printer is working.
3. During building, you can change printing temperature and speed, even pause or
cancel printing. Tap control knob, the menu lists these options. Use control knob to
select and enter.

Print

Filament
Setup About

*NOTES

1. Recommended ambient operation temperature: 25°C - 30°C.
2. Before building, make sure the build plate is fixed and clean.
3. Keep the machine away from any liquid. Or, it may get damaged.
4. The nozzle temperature is over 200°C when the printer is operating. Avoid touching.
5. ABS will produce a strong smell when building, so please keep ventilated.
6. Pause to change new filament when material is running out. You can even load filament during
building. Just remember DO NOT move the position of print head, otherwise the print will be destroyed.
Thanks again for choosing MBot personal 3D printer!
Address: 14th Floor,Block A,Huaye Building,511 Jianye Road,Binjiang District | Hangzhou, ZJ | 310052 | CHINA
Technical support email: support@mbot3d.com
Email： info@mbot3d.com
http://www.mbot3d.com
tesst.x3g
MBot_testprint.x3g
MBot_Leuelling.x3g
lan.x3g
M-stand-g2.x3g
test
52%
. ... ... .. .
Au to- le av el OF F
1 0:38
21 9/ 22 0℃