Loading Filament - MBot Grid II+ Quick Start Manual

MBot Grid II+ 3D Printer QUICK START GUIDE
●LOADING FILAMENT
1. Select [Change Filament] in main menu, and press the control knob to enter.
2. Turn the control knob to select [Feed] mode and press it to enter. Then the print head starts to heat up.
Print Filament
Setup About
3. When the print head reaches the pre-set temperature, the machine gives notification tone, and the
screen prompts "Feeding". Now load the filament through filament tube into the feeding hole, till the
print nozzle starts extruding material.
*NOTES:
To feed smoothly, please insert spool holder and filament spool into the square holder mount on the
back of the printer.
When restoring your machine to factory settings or replacing the motherboard, go to "Settings –Gener-
al Settings" and turn on FILAMENT MONITOR (otherwise, X-axis does not move). Restart the printer
every time after changing the settings.
4. Tap the control knob to exit feeding and return to the main menu.
Filament
Preheat
Load
Unload
Exit menu
LOAD FILAMENT
Heating...
.. ... ... .. ... .. ..
032℃