Flute; Trumpet - AKG C535 EB User Instructions

Frequency components between 800 Hz and 3 kHz are radiated
exclusively from the keys. At higher frequencies, radiation shifts
toward the bell. Frequencies above 5 kHz are radiated through the
bell only.
In order to attain a well-balanced tone, mount the C535 EB on a
it roughly toward the lowest key.
4.4

Flute

player. With frequencies higher than 3 kHz, preferred radiation
which kind of music is performed. Depending on the desired tone
color, the C535 EB may be placed one to two inches, or 4 to 8
inches in front of the performer's lips. It is advisable to blow to the
side of the microphone, in order to avoid excessive wind noise.
With extremely short working distances, it is best to blow below the
microphone.
During the actual performance, the position of the player's lips
relative to the microphone should, if possible, remain unchanged.
If it is necessary to capture the high frequency components above
3 kHz, too, use an additional microphone, e.g. the condenser
microphone C451 B.
4.5

Trumpet

As opposed to other instruments, microphone placement for
trumpets is easy because of the instrument's radiation pattern: up
to about 500 Hz the sound is evenly distributed in all directions.
Midrange frequencies are radiated through the bell over a large
angle in the playing direction, the angle narrowing with rising
frequency. Above 5 kHz the radiation angle is about 30°.
away from the instrument, at an acute angle with it. Thus, the trum-
pet player will not blow directly into the microphone so as to avoid
C535 EB MANUAL
USING THE MICROPHONE
Flute
Trumpet
35