Slide Tray - Kodak 750 Manual

8
SLIDE TRAY
Furnished with the projector is a slide tray that holds 80
slides. The tray accepts 126 (28 x 28mm), 135 (24 x 36mm),
828 (28 x 40mm), and 127 (1 X x 1 X -inch) slides in cardboard,
glass, metal, or plastic 2 x 2-inch mounts. The KODAK
CAROUSEL Slide Tray accepts slides up to '/,
0
inch thick;
the KODAK CAROUSEL Universal Slide Tray accepts
slides up to
Ya
inch thick. Slides mounted with loose or
sticky tape, or mounts that have sharp glass corners are not
recommended for use in the slide tray. Slide-identification
numbers are molded onto the tray. As the tray revolves, the
number of the slide being shown will be opposite the gate
index on the projector.
LOADING SLIDE TRAY
Check to be sure that the LOCK on the bottom of the tray is
engaged in the NOTCH in the metal slide-retainer. If it is
not, turn the retainer until the lock engages the notch in
the retainer.
Remove the lock ring from the top of the tray by turning it
in the direction of the arrow marked UNLOCK; then lift off
the ring. Insert a slide in each slot in the tray, with the top of
the picture down. The printed border or trademark side of
each cardboard-mounted slide-or the emulsion (dull) sur-
face of a slide mounted in glass, metal, or plastic-should
face the next lower number. For example, the bordered,