Kodak 750 Manual page 14

14
PROJECTION-LAMP REPLACEMENT
You have a choice of two projection lamps-ASA Code
DEK (average 25-hour lamp life with power switch at HIGH
-500-watt illumination and average 100-hour lamp life with
power switch at LOW-425-watt illumination) or ASA Code
CBA (average 50-hour lamp life with power switch at HIGH
-500-watt illumination and average 200-hour lamp life with
powerswitchat LOW-425-wattillumination).lfyou decide to
install an ASA Code CBA lamp, observe several precautions:
1. Always grasp the lamp by the ceramic cap which fits
over the top of the lamp.
2. To avoid leaving fingerprints, be careful not to touch
the transparent portion of the lamp. If fingerprints are
left on the lamp, wipe it carefully with a clean, soft cloth
soaked in rubbing alcohol.
3. Leave the ceramic cap on the CBA lamp to insure
adequate heat dissipation.
CAUTION: Be certain that the projector and the projec-
tion lamp have cooled before you replace the lamp.
To replace a lamp, turn the projector bottom side up. Open
the LAMP DOOR by turning the coin-slotted door screw
counterclockwise until the door can be opened to the posi-
tion illustrated . Do not force the door farther. Push the lamp
RELEASE LEVER upward toward the lamp door to release
the lamp from the socket. Then lift out the lamp.
To install the new lamp, first push the lamp release lever
downward to its original position. Then place the center
post of the lamp in the center hole of the socket and rotate
the lamp until the key on the center post locates in its socket
slot. Push the lamp in all the way. Close and secure the
lamp door.