Line Voltage And Fuse; Composition 4-Channel Stereo System; Performance Of Qx-8000; Changing Line Voltage Setting And Fuse - Pioneer qx-8000 Operating Instruction

LINE VOLTAGE AND
FUSE
CHANGING LINE VOLTAGE SETTING AND
FUSE
To
remove the
fuse,
turn the
fuse cap located
on the
line
voltage selector in the direction indicated by the arrow. Then
remove the
fuse
plug from the unit. Put the
fuse
plug back
so
that the
proper line voltage marking
can be seen
through the
cut
in
the
edge
of
the plug.
Whenever
the position of
the
selector
is changed,
check
the rating of the fuse. A
1.5-ampere
fuse is to
be used
for
either 220Y or 240V operation and
a
S-ampere
fuse
for
110V, 120V or 130V
operation.
if
the
rating of the fuse
is
correct, replace
cap.
FUSE REPLACEMENT
If the
fuse blows, remove
the
fuse
with
a new
one.
fuse cap and
replace the
TJIONEEFI
Fig.
1
4-channel stereo system, the QX-8000,
stereo receiver, can be combined with
tape decks, turntables, etc.
as
shown in
network
(separately available Pioneer
installed
as
shown
in
Fig. 2, a
2-way
can
be set up.
CARTRIDGE
TURNTABLE
TAPE
DECK
TAPE PLAYER
TURNTABLE
TAPE
DECK
CARTRIDGE
TAPE PLAYER
COMPOSITION
A
4-CHANNEL STEREO
SYSTEM
To
compose
an ideal
a solid
state AM/FM
four
speaker systems,
Fig.
1.
If
electronic
crossover
SF-500
or
SF-700)
is
multiamplifier
system
PERFORMANCE OF
QX.SOOO
4-CHANNEL STEREO PERFORMANCE
With a
4-channel stereo tape deck
or
cadridge tape player
installed,
the
QX-8000 can provide
a
4-channel
stereo
playback of programs recorded on
tape.
4-CHANNEL STEREO
PERFORMANCE OBTAINABLE
FROM
A
2-CHANNEL STEREO
SOURCE
A
2-channel program source (a record,
recorded tape, FM
stereo program, etc.) can be reproduced in
a
high degree
of
a
4-channel stereo performance by
either
MATRIX
system
or
PHASE
SHIFT
system through
the provision
of
QUAD-
RALIZER circuit in the
QX-8000.
For this
4-channel stereo
performance,
two
speaker systems
must be installed
in
the
front
and
two
speaker systems
in
the
rear.
For the QUADRALIZER circuit,
see
page
14.
2-CHANNEL STEREO PERFORMANCE
A
conventional 2-channel stereo performance can be provid-
ed through an
arrangement
of
two
speaker systems
in
the
front;
left-side speaker system (CH. 1) and right-side
speaker
system (CH.
3).
A
2-way multi-amplifier system
can be set
up by installing
an
electronic
crossover
network
(see
Fig. 2).
SPEAKER SYSTEMS
ELECTRONIC
CROSSOVER
NETWORK
(SF-7OO
or
SF-5OO)
Fig.
2