Advertisement
Advertisement
Table of Contents
Related Manuals for Bullet ZPS
Summary of Contents for Bullet ZPS
- Page 1 Electric Scooter Owner’s Manual Page1...
-
Page 2: Charging Instructions
PLEASE BE SAFE WHEN RIDING ALWAYS WEAR A HELMET AND OBEY ALL LAWS! IMPORTANT 注意 BATTERY MAINTENANCE and CHARGING INSTRUCTIONS You MUST charge completely prior to initial use. (Follow charging instructions in your Product Handbook) 1. Charge immediately after each use. 2. -
Page 3: Read This First
IMPORTANT PLEASE READ THIS BEFORE USING THIS PRODUCT READ THIS FIRST! WARNING Persons without excellent vision, balance, coordination, reflex, muscle and bone strength and good decision-making capabilities should not use this product. User: 7+ ages, suggest use the product with adult supervision at all times. ... -
Page 4: Getting Started
GETTING STARTED Please read and understand these instructions and the OPERATING PROCEDURES section, prior to starting or riding your ELECTRIC SCOOTER Assembly 1. Open the box, and take out the scooter and pneunatic front tyre, then fix the front tyre（photos ②... - Page 5 3. Handlebar fixing; a. Place the handlebar (1) into the steering stem clamp (2) so that it is centered and resting in the channel. b. Place the steering stem top clamp (3) into position over the handlebar. Fasten it using 2 M5 screws.
- Page 6 Charging WARNING: Do not allow your scooter to go into deep discharge, as this will damage the batteries. 1. Make sure unit is turned off. 2. Charging socket is located on side. (see picture below) 3. Locate your Battery Charger. Find the charger socket end that has a single-prong socket and plug it into the scooter.
- Page 7 Circuit Breaker When the current is too high, the fuse will pop up, you only need to press it down, the scooter can work again, no need to change fuse Riding 1. Make sure that all of the exposed bolts and screws are tightened. 2.
-
Page 8: Braking System
BRAKING SYSTEM The ELECTRIC SCOOTER uses a hub brake system on the rear wheel. A hand brake lever on the left side of the handlebar activates the brakes. Squeezing the hand brake lever with your left hand will activate the rear brake. Make sure to release the HAND THROTTLE GRIP when engaging the brakes. -
Page 9: Recommended Tools
MAINTENANCE RECOMMENDED TOOLS To adjust and service the ELECTRIC SCOOTER you will need the following tools: Allen Wrenches: M5，M2.5 Wrenches: M13-15，M8-10 MAINTENANCE SCHEDULE Proper care of your ELECTRIC SCOOTER will insure optimal performance and longer life span. The following are a few maintenance suggestions that will keep your ELECTRIC SCOOTER running in top condition: Daily Maintenance Perform each time you ride your ELECTRIC SCOOTER... - Page 10 Some experts believe the incorrect or prolonged use of almost any product could cause serious injury or death. For information that may reduce your risk of serious injury or death consult thepoints below and additionall y , the information available at www.datastreamserver.com/safety - Consult all documentation, packaging and - The product has been supplied by a general merchandise...
Need help?
Do you have a question about the ZPS and is the answer not in the manual?
Questions and answers
what position should I turn the switch to when charging the scooter (Bullet ZPS)?
The switch should be in the "CHA" (charging) position when charging the Bullet ZPS scooter.
This answer is automatically generated