Table of Contents
Advertisement
Operations
Receive mode
Problem
I cannot select the desired receive
mode.
Copying
Problem
The unit does not make a copy.
A dirty pattern or a black line
appears on the copied document.
The copied image is distorted.
The printing quality is poor.
The printing is faint.
Original
ABC
The document is not copied properly.
The copied document is blank.
A paper jam occurs during copying.
Answering device (KX-FP121/KX-FM131 only)
Problem
No voice messages have been
recorded in the TAD/FAX mode.
I cannot retrieve recorded messages
from a remote telephone.
116
If you want to set the TAD/FAX (KX-FP121/KX-FM131 only),
FAX ONLY or TEL/FAX mode:
– Select the desired mode using feature #77 (p. 73, 78), and
– Press
If you want to set the TEL mode:
– Press
You cannot make a copy during programming. Make the copy
after programming or stop the programming.
The glass or rollers are dirty. Clean them (p. 126).
The center rib is dirty. Clean it (p. 126).
The thermal head is dirty. Clean it (p. 126).
Some paper has instructions recommending which side to print
on. Try turning the paper over.
You may have used paper with a cotton and/or fiber content that
is over 20%, such as letterhead or resume paper.
Copy
The film is not inserted correctly. Insert it correctly (p. 124, 125).
The film is not inserted correctly. Insert it correctly (p. 124, 125).
The film is not inserted correctly. Insert it correctly (p. 124, 125).
The memory is full. Erase some or all of the messages
(p. 98, 104).
Make sure that you use the remote operation ID correctly
(p. 102).
Cause & Remedy
to turn on the AUTO ANSWER light.
AUTO ANSWER
to turn off the AUTO ANSWER light.
AUTO ANSWER
Cause & Remedy
Cause & Remedy
AUTO ANSWER
FAX ON
ON
AUTO ANSWER
FAX ON
OFF
Advertisement
Table of Contents
