Firmware Update - Onkyo NC-500 Service Manual

FIRMWARE UPDATE - 1

Arrangements for PC
1
Make the firmware folder under the Net-Tune Central folder.
2
Make the folder of a suitable name (ex.:FWNC500) in that.
3
Putting the following 4 files in that.
Fdist.fdf - File Distribution File
FW_0_1_0.dcf - Device Construciton File
LanY08na.mot - The program of Network microprocessor (The file name changes by the version).
LanY08rb(L).mot - The program of System microprocessor (The file name changes by the version)
4
Start Net-Tune Central.
Note!
Update initializes each setting data.
Put only the folder which puts firmware in the firmware folder. And, do not make the folder of the subordinate position from it.
When you replaces or edits the above file, you should end Net-Tune Central once, and restart. Otherwise, the change is not reflected.
Update Utility : ON
SETUP
STANDBY
state
* Pushing two keys is continued
5 seconds or more.
Update Utility : STOP
SETUP SETUP
Display
Update Utility
CANCEL Version Check
The state
which passed
20 seconds or
more after
POWER ON
Memory Clear
The state
which passed
20 seconds or
more after
POWER ON
Update Utility
1.F/W Update
It takes about 20 seconds.
STANDBY / ON
DISPLAY
STANDBY / ON
NC-500
Display