Table of Contents
Advertisement
9.3 Advanced features
Code #22: Setting the journal report to print
automatically
AUTO JOURNAL
=ON
[±]
"ON" (default): The unit will print a journal report
automatically after every 30 new fax
transmissions and receptions (page 40).
"OFF": The unit will not print a journal report, but
will keep a record of the last 30 fax transmissions
and receptions.
Code #23: Sending documents overseas
OVERSEAS MODE
=ERROR
[±]
If you cannot send a fax overseas even if the
number is correct and the line is connected,
activate this feature before sending the fax.
This feature improves the reliability by reducing
the transmission speed.
"ERROR" (default): When the previous fax
transmission fails and you wish to re-send the
document.
"NEXT FAX": This setting is effective only for the
next attempted fax transmission. After
transmission, the unit will return to the previous
setting.
"OFF": Deactivates this feature.
Note:
L This feature is not available for broadcast
transmission.
L Calling charges may be higher than usual.
Code #25: Sending a fax at a specific time
DELAYED SEND
=OFF
[±]
This feature allows you to take advantage of low-
cost calling hours offered by your telephone
company. This feature can be set up to 24 hours
in advance of the desired time.
To send a document:
1. Insert the document.
2. If necessary, press {A} or {B} repeatedly to
select the desired resolution (page 40).
3. Press {MENU}.
4. Press {#} then {2}{5}.
5. Press {A} or {B} repeatedly to select "ON".
6. Press {SET}.
7. Enter the fax number.
9. Programmable Features
8. Press {SET}.
9. Enter the transmission start time.
L If you select 12-hour time entry when you
set the date and time (page 20), press
{*} repeatedly to select "AM" or "PM".
L If you selected 24-hour time entry when
you set the date and time (page 20), the
time is set using 24-hour time entry.
10. Press {SET}.
11. Press {MENU}.
Note:
L To cancel after programming, press {STOP}
then {SET}.
Code #26: Setting the caller information list
to print automatically
AUTO CALL. LIST
=OFF
[±]
"ON": The caller information list will be printed
automatically each time the unit logs 30 callers
(page 35).
"OFF" (default): The caller information list will
not be printed, but the unit will keep a record of
the information for the last 30 callers.
Code #28: Setting call bar
CALL BAR
PRESS SET
This feature prohibits making outside calls with
the base unit. When call bar is turned ON, only
intercom calls and emergency calls can be
made. To store emergency numbers, see page
73.
1. Press {MENU}.
2. Press {#}, then {2}{8}.
3. Press {SET}.
4. Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page 73).
5. Press {A} or {B} repeatedly to select "ON".
6. Press {SET}.
7. Press {MENU}.
Note:
L When call bar is turned ON, o is displayed
on the base unit.
L To prohibit making outside calls with the
cordless handset, see page 71.
Code #31: Activating the Distinctive Ring
feature
DISTINCTIVE RING
=OFF
[±]
63
Advertisement
Table of Contents
