Cushman Refresher FS2 Owner's Manual page 49

Item
Engine
Rear axle
S General lubrication
Throttle/governor linkage
E Fuel system
Front axle
Parking brake
S Engine electrical system
S Rear suspension
S Front suspension
Front wheel alignment
S Battery
King pins
Rear axle
S
Air filter
E
S Oil filter
S Engine oil
CVT belt
Direction selector
Steering
Rack end ball joint
S Rear axle
S Front wheel bearings
S Brakes
S Muffler/exhaust system
Valves - intake/exhaust
S
Spark plug
E
S Fuel filter
Carburetor
Cylinder head and piston
Cylinder head and piston
Rear axle
Interval
(perform at interval
that comes first)
Hours Calendar
20 Monthly Check for unusual noise, vibration, acceleration, oil leaks.
20 Monthly Check for leakage; add oil as required.
50 3 Months Lubricate all fittings, pivots, cables, etc. where required.
50 3 Months Check operation and governed speed.
50 3 Months Check for leakage at tank, cap, lines, filters, pump, carburetor.
50 3 Months Check for damage, loose or missing hardware.
Inspect linkage rods, latch arm, catch bracket.
50 3 Months
Lubricate with light oil (Do not lubricate cables or brake latch).
50 3 Months Check coil/spark plug wires for cracks or loose connections.
Inspect shocks for leaks, worn bushings, loose or missing
50 3 Months
hardware.
Inspect strut for leaks. Check hubs and kingpins, for excessive
50 3 Months
play, worn bushings, loose or missing hardware.
50 3 Months Inspect for unusual tire wear; align if necessary.
125 6 Months Inspect terminals. Clean as needed.
125 6 Months Check for excessive play and tightness of retaining nuts.
125 6 Months Check for unusual noise, loose or missing hardware.
125 6 Months Inspect; clean or replace as necessary.
125 6 Months Replace (with oil change).
Replace. See RECOMMENDED LUBRICANTS AND FLUIDS
125 6 Months
on page 48 for type and capacity.
125 6 Months Inspect for cracks, fraying and excessive wear.
Check for wear and smooth movement; lubricate shaft with
125 6 Months
light oil if necessary.
125 6 Months Inspect bellows and pinion seal for damage and leakage.
125 6 Months Check for noise and loose or missing hardware.
250-300 Yearly Check fluid level; add if required.
250-300 Yearly Check and adjust as necessary.
Clean and adjust.
250-300 Yearly
Check brake shoe linings; replace if necessary.
Check hardware. Inspect for leaks at head and muffler gas-
250-300 Yearly
kets.
250-300 Yearly Check cold.
250 Yearly Replace and gap new.
250 Yearly Replace.
500 5 years Clean.
500 5 years Remove carbon.
500 5 years Check valve seats for carbon buildup; clean if necessary.
500 5 years Replace fluid.
V M
EHICLE AINTENANCE
Remarks Page
48
60
48
58
47