Refresher Unit; Refresher Unit Overview; Unit Components - Refresher Fs2; Unit Components - Refresher Nsf And Oasis - Cushman Refresher FS2 Owner's Manual

REFRESHER UNIT OVERVIEW

The REFRESHER unit is designed for inventory of unopened, pre-packaged, non-perishable foods for daily distribu-
tion. It is not intended for long term food storage or storage of opened food and beverage items. Adherence to local
food handling regulations is required.

UNIT COMPONENTS - REFRESHER FS2

• windshield with frame
• struts and canopy top
• two (2) lockable, insulated, sliding drawers
• two (2) lower storage cabinets with three (3) shelves and three (3) snack trays
• slide-out trash/recycle storage bin system
• two (2) removable plastic bins
• two (2) lower, rear, corner storage compartments
• locking system for holding and changing modules
• counter top
• left and right side mirrors
• 24" of module space to meet adjustable storage needs
• shelves in upper rear end cap

UNIT COMPONENTS - REFRESHER NSF AND OASIS

• windshield with frame
• struts and canopy top
• beverage tank with dividers
• lift-up lids to access side storage compartments
• dry products cabinet with four doors, four fixed shelves, two boxes
• left and right side mirrors
• air pots with hold strips (optional on OASIS)
• reversible bottle/air pot holder (optional on OASIS)
• ice sink (optional on OASIS)
• consumable ice bin (optional on OASIS)
• humidor (optional)

SERIAL NUMBER LOCATION

The REFRESHER unit serial number is located on the inside of the right, rear door of the end cap.

EMISSIONS LABELS AND ENGINE ACCESS

REFRESHER FS2

Remove the side drawer from it's position to view the engine compartment.
1. Remove the two screws from underneath the front of the drawer.
2. There are tabs in the rear that help hold the drawer frame in place. Lift
up on the front of the drawer and gently pull the drawer out to disen-
gage the tabs. It may be necessary to work the drawer up and down
slightly while pulling gently to release it from the tabs.
The emission labels are visible when the engine compartment is accessed.
Install the drawer:
1. Slide the drawer straight back into the opening.
2. Lightly push down on the front of the drawer to lift the rear up slightly, while continuing to slide the drawer in. It
may be necessary to work the drawer up and down slightly to lock the drawer into place correctly.
3. When installed, push down on the front of the drawer to verify correct fit. The rear of the drawer should not move.
4. Install the screws.

REFRESHER UNIT

R
EFRESHER
REFRESHER FS2 shown
U
NIT
27