TP-Link TL-ER604W User Manual page 80

TL-ER604W supports both RIPv1 version and RIPv2 version, thus you can configure the RIP version
based on the actual need to improve the network performance.
Choose the menu Advanced→Routing→RIP to load the following page.
The following items are displayed on this screen:
 General
Interface:
Status:
RIP Version:
Password
Authentication:
All Interfaces:
 List of RIP
After RIP is enabled, the information of RIP forwarding the packets received by the Router will be
displayed in the list.
The first entry in Figure 3-48 indicates: when receiving packets with destination IP is 116.10.20.28, the
Router will select WAN1 which is in the same network with the destination IP as next hop and forward
Figure 3-48 RIP
Displays the interfaces which has been physically connected or assigned
static IP.
Enable or disable RIP protocol.
Select RIPv1 or RIPv2. RIPv2 supports multicast and broadcast.
If RIPv2 is enabled, set the Password Authentication according to the actual
network situation, and the password should not be more than 15 characters.
Here you can operate all the interfaces in bulk. All the interfaces will not apply
RIP if "Enable" option for All Interfaces is selected.
-75-