Table of Contents
Advertisement
Setting the Internet Parameters
Setting the User (Internet) Parameters
Before starting, you will need a completed copy of page 19 (Pre Installation Information). For your machine
to be able to operate on the Network properly, the following five (5) Basic Parameters must be pre-
programmed into the machine.
• IP Address
• Subnet Mask
• Default Gateway IP Address
• SMTP Server Name or IP Address
• Email Address
Note:
If DHCP server is available on your network, the IP Address, Subnet Mask and Default Gateway
IP Address will be acquired automatically.
1
2
1
3
4
Enter the IP Address using the keypad. Press
to enter the period ".". (See Note 3)
Ex:
1 2 3
5
To continue setting other parameters, or press
to return to standby.
NOTE
1. To scroll the display to desired User Parameter in Step 3, press
2. If the DNS Server is not available, change the setting of the Fax Parameter No. 161 (DNS
SERVER) to "Invalid", then enter the IP Address instead.
3. For convenience, you can use
Otherwise
7
repeatedly until display shows;
1 7 8
2 4 0
is used to enter an asterisk under other conditions.
SET MODE
ENTER NO. OR
1:USER PARAMETERS?
PRESS SET TO SELECT
IP ADDRESS
❚
IP ADDRESS
or
123.178.240.3❚
3
SUBNET MASK
❚
STOP
to enter a period "." while programming IP Addresses only.
(1-8)
∨ ∧
or
.
49
Advertisement
Table of Contents
