Table of Contents
Advertisement
Email ABBR Programming Errors
Error Message Sent to the Sender
Error messages that are emailed from your machine to the original sender during remote programming of
the Auto Dialler via email.
Error message
1
554 Data transfer error (broken header)
2
554 Data transfer error (broken data)
3
554 Data transfer error (FAX module)
4
554 MIME attachment not supported
(message/file)
5
554 MIME format not supported
6
554 G3 relay permission denied
7
554 Relay address unknown
8
554 Memory full (FAX module)
9
554 Data transfer error
Internet FAX Return Receipt Errors Messages
Error messages that are printed on the Internet Fax Return Receipt when remote programming of the Auto
Dialler via email fails.
Error message
1
Format Error : <@command block, the
"@end" command is missing.>
2
Format
Error
:
<@begin
"@begin" command is missing.>
3
Format Error : <@begin block, the "@end"
command is missing.>
4
Format Error : <@system block, the
"@end" command is missing.>
5
Format Error : <@sender block, the
"@end" command is missing.>
6
Format Error:<@domain block, the "@end"
command is missing.>
7
Format Error : <@program block, the
"@end" command is missing.>
8
Format Error : <@system block, the
"@system" command is missing.>
9
Permission
denied
parameter is set to "Valid".>
10
Permission denied : <Fax machine is busy
performing a task.>
The header or sub header decoding is being processed while the
message finished, try again.
Multiple contents are present and being processed while the
message finished, try again.
Data transfer error occurred in the FAX module while communicating
with the LAN module, try again.
MIME attachment is not supported during this operation, re-send
using plain text in the message body only.
MIME file type is not supported, re-send using plain text in the
message body only.
The requested domain for Relayed XMT is not registered.
The telephone number of end receiving station for the Relayed XMT
is unknown.
FAX Memory is full, try again later.
Other errors not listed above, try again later.
The block termination command "@end" is missing in the
"@command" block, add the "@end" command and try again.
block,
the
The block start command "@begin" is missing in the "@begin" block,
add the "@begin" command and try again.
The block termination command "@end" is missing in the "@begin"
block, add the "@end" command and try again.
The block termination command "@end" is missing in the "@system"
block, add the "@end" command and try again.
The block termination command "@end" is missing in the "@sender"
block, add the "@end" command and try again.
The block termination command "@end" is missing in the "@domain"
block, add the "@end" command and try again.
The block termination command "@end" is missing in the
"@program" block, add the "@end" command and try again.
The system block start command "@system" is missing in the
"@system" block, add the "@system" command and try again.
:
<Fax
Forward
Change the Fax Forward parameter to "Invalid" and try again.
Try again later when the machine is not busy.
Troubleshooting
Possible cause
Possible cause
229
Advertisement
Table of Contents
