Before Use; Avant Utilisation - Teac w-600r Owner's Manual

IMPORTANT
(for U.K.Customers)
DO NOT cut off the mains plug from this
equipment. If the plug fitted is not suitable
for the power points in your home or the
cable is too short to reach a power point,
then obtain an appropriate safety approved
extension lead or consult your dealer.
If nonetheless the mains plug is cut off,
remove the fuse and dispose of the plug
immediately, to avoid a possible shock
hazard by inadvertent connection to the
mains supply.
If this product is not provided with a mains
plug, or one has to be fitted, then follow the
instructions given below:
IMPORTANT. DO NOT
connection to the larger terminal which is
marked with the letter E or by the safety
earth symbol | or coloured GREEN or
GREEN-and-YELLOW.
The wires in the mains lead on this product
are coloured in accordance with the
following code:
BLUE : NEUTRAL
BROWN : LIVE
As these colours may not correspond with
the coloured markings identifying the
terminals in your plug proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured BLACK.
The wire which is coloured BROWN must
be connected to the terminal which is
marked with the letter L or coloured RED.
When replacing the fuse only a correctly
rated approved type should be used and be
sure to re-fit the fuse cover.
IF IN DOUBT — CONSULT A COMPETENT
ELECTRICIAN.
2
Read this before operation
< Choose unit installation location carefully.
Avoid placing it in direct sunlight or close
to a source of heat. Also avoid locations
subject to vibrations and excessive dust,
heat, cold or moisture. Keep away from
sources that hum, such as transformers or
motors.
< Do not open the cabinet as this might
result in damage to the circuitry or
electrical shock. If a foreign object should
get into the set, contact your dealer.
< When removing the power plug from the
wall outlet, always pull directly on the
plug, never yank the cord.
< Do not attempt to clean the unit with
chemical solvents as this might damage
make any
the finish. Use a clean, dry cloth.
< Keep this manual in a safe place for future
reference.
Basic description of Dolby NR
During low-level program material, Dolby
NR acts to boost high-frequency signals.
During playback, these signals are
restored to their original level. Any noise
introduced in between these processes
(during recording) will be reduced in
playback. Dolby NR also employs the
principle of least treatment, leaving high-
level signals unprocessed since the
louder program material serves to
effectively mask any tape hiss.
Dolby noise reduction manufactured under
license from Dolby Laboratories Licensing
Corporation.
"DOLBY" and the double-D symbol U are
trademarks of Dolby Laboratories
Licensing Corporation.

Before Use

ENGLISH

Avant Utilisation

Lire ceci avant de faire fonctionner
l'appareil
< Choisir avec soin l'endroit où vous
placerez votre appareil. Eviter de le placer
directement au soleil ou près d'une
source de chaleur. Eviter aussi les
endroits sujets à des vibrations, à de la
poussière excessive, à la chaleur, au froid
ou à l'humidité. Toujours le garder éloigné
de sources de bourdonnements telles que
des transformateurs ou moteurs.
< Ne pas ouvrir le coffret car ceci risquerait
de provoquer des dommages aux circuits
ou des chocs électriques. Si un objet
rentre dans l'appareil, contacter votre
revendeur.
< Lors du débranchement du cordon
d'alimentation de la prise murale, toujours
tirer sur la fiche et non sur le cordon.
< Ne pas essayer de nettoyer l'appareil
avec des solvants chimiques car ceci
pourrait endommager le fini de l'appareil.
Utiliser un chiffon propre et sec.
< Garder soigneusement ce manuel
d'instructions pour une référence
ultérieure.
Principe de fonctionnement du Dolby NR
Le dispositif de réduction de bruit Dolby
NR fonctionne en renforçant les signaux
de fréquence élevée lorsque le
programme est à un niveau faible. A la
lecture, ces signaux sont ramenés à leur
niveau d'origine. Tout bruit introduit entre
ces deux processus, c'est-à-dire pendant
l'enregistrement, sera réduit à la lecture.
Le dispositif Dolby NR obéit également au
principe de traitement minimum, c'est à
dire en ne traitant pas les signaux de
niveau élevé puisqu'un niveau sonore
plus élevé a pour effet de masquer
suffisamment tout sifflement sur la bande.
Réduction de bruit Dolby fabriquée sous
licence de Dolby Laboratories Licensing
Corporation.
DOLBY et le symbole double-D U sont
des marques de Dolby Laboratories
Licensing Corporation.
FRANÇAIS