Weslo CADENCE CT 5.8 WLTL27308.1 User Manual page 12

12. Attach the Latch Housing (85) to the Left Upright
(86) with two #10 x 1" Tek Screws (7). Make
sure that the Latch Housing is oriented as
shown.
Locate the Latch Pin Assembly (84). Remove
the knob from the pin. Make sure that the collar
and the spring are on the pin as shown. Insert
the pin into the Latch Housing (85), and tighten
the knob back onto the pin.
13. Attach each Incline Leg (63) to the Frame (61)
with an M8 x 52mm Bolt (8), two M8 Washers
(10), and an M8 Nut (16).
14. Insert the Incline Pins (62) at the desired incline
level (see HOW TO CHANGE THE INCLINE OF
THE TREADMILL on page 17 ).
15. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys
in a secure place. One of the hex keys is used to adjust the walking belt (see page 21). To protect the floor or
carpet, place a mat under the treadmill.
12
84
85
Knob
7
Large Hole
13
61
63
10
8
10
14
62
12
86
Spring
Collar
Pin
63 10
8
16
10
62