Accessories; Maintenance - RIDGID R175RNE Operator's Manual

MAINTENANCE

REQUIRED DAILY CHECKLIST
See Figure 10, page 16.
 Disconnect the air supply from the tool and remove all
fasteners.
 Check all screws, nuts, bolts, and pins on the tool. If
any of these are loose, they must be tightened with the
appropriate size wrench.
 Press the workpiece contact against a workpiece to
ensure that it moves smoothly.
 With the workpiece contact depressed, pull the trigger.
The trigger should move smoothly, without binding.
 While the tool is not loaded, connect the appropriate air
supply (at 70 psi) to the tool.
 Select Single Sequential Actuation operation, Position A.
No air should leak from the tool.
• Without pulling the trigger, press the workpiece
contact against a workpiece several times. The tool
must not operate.
• With the workpiece contact not engaged on the
workpiece, point the tool down and away and pull
the trigger several times. Hold the trigger in this
position for a minimum of 5 seconds. The tool must
not operate.

ACCESSORIES

To order parts and maintenance kits, call 1-866-539-1710.
Driver Maintenance Kit ....................................................................................................................................079006005701
Overhaul Kit .....................................................................................................................................................079006005702
Oil and Wrench Kit...........................................................................................................................................079006005704
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
• Press the workpiece contact firmly against the
workpiece and pull the trigger. The tool must operate.
• With the workpiece contact still depressed, release
the trigger. The driver must return to its up position.
 Select Contact Actuation operation, Position B.
• With the workpiece contact not engaged on the
workpiece, point the tool down and away. Pull the
trigger. The tool must not operate.
• Keeping the trigger fully depressed, push the workpiece
contact against a workpiece. The tool must operate.
 If the tool successfully meets all the requirements in this
checklist, it is ready for use. Set the trigger on the tool
to operate in the manner that best fits your application.
Load the proper fasteners for the desired application.
 Set the depth of drive according to the "Drive Depth
Adjustment" section in this manual. Repeat this checklist
before using the tool each day, or if the tool is dropped
or damaged in any way.
13 – English