Page 1
RE 6/RE 60 Manual Electrical Tool 99 Washington Street Melrose, MA 02176 Phone 781-665-1400 Toll Free 1-800-517-8431 Visit us at www.TestEquipmentDepot.com...
Failure to understand and follow the contents of RE 6/RE 60 Electrical Tool this manual may result in Record Serial Number below and retain product serial number which is located on nameplate. electrical shock, fire and/or serious personal injury.
RE 6/RE 60 Electrical Tool Safety Symbols In this operator’s manual and on the product, safety symbols and signal words are used to communicate important safe- ty information. This section is provided to improve understanding of these signal words and symbols.
RE 6/RE 60 Electrical Tool Personal Safety er tool or these instructions to operate the power tool. Power tools are dangerous in the hands of • Stay alert, watch what you are doing and use com- untrained users. mon sense when operating a power tool. Do not •...
The RIDGID ® Models RE 6 and RE 60 Electrical Tools are • Never repair a damaged head. A head that has electro-hydraulic tools, which when used with appropriate been welded, ground, drilled or modified in any man- interchangeable heads perform a variety of functions, ner can break during use.
Amperage ....18 Amp tromagnet interference to other equipment. Power .....324 Watts The RIDGID Model RE 6 and RE 60 Electri - ® NOTICE Battery......18V Li-Ion, Rechargeable cal Tools conform to all applicable EMC standards.
RE 6/RE 60 Electrical Tool Tool Inspection • Any other condition which may prevent safe and normal operation. WARNING If any problems are found, do not use the tool until the problems have been repaired. 4. Inspect and maintain any other equipment being used per its instructions to make sure it is functioning prop- erly.
2. Inspect the work to be done and determine the cor- 6. With dry hands, install a fully charged battery into the rect RIDGID tool and interchangeable head for the electrical tool. Press the ON/OFF (Figure 2) button to application. Using an incorrect interchangeable head power on the electrical tool.
RE 60. To prevent serious injury, use only accessor - ies specifically designed and recommended for use Service and repair on this RE 6/RE 60 Electrical Tool with the RE 6 or RE 60, such as those listed below. must be performed by an independent Crimp Tool Service Catalog Cent er.
RE 6/RE 60 Electrical Tool Disposal For EC Countries: Do not dispose of elec- trical equipment with household waste! Parts of the Electrical Tool contain valuable materials According to the European Guideline 2012/ - and can be recycled. There are companies that specialize 19/ EU for Waste Electrical and Electronic in recycling that may be found locally.
RE 6/RE 60 Electrical Tool Troubleshooting (Continued) SYMPTOM POSSIBLE REASONS SOLUTION Oil leaks from tool. Seal or mechanical problems. Contact Ridge Tool Technical Service Department at (800) 519-3456 for nearest Independent Service center. Oil level low. Contact Ridge Tool Technical Service Department Motor runs but tool will not complete a cycle.