Clevo W150ERQ Service Manual page 38

Disassembly
Processor Installation Procedure
Figure 10
Processor
1. Insert the CPU
Installation
FORCE IT!), and turn the release latch
2. Remove the sticker
a. Insert the CPU. 3. Insert the heat sink
b. Turn the release latch to-
4. Tighten the CPU heat sink screws in the order
wards the lock symbol.
Figure
c. Remove the sticker from
and its position should be at a 90 degree angle from the mainboard.
the heat sink and insert
5. Replace the component bay cover (don't forget to replace the fan cable) and tighten the screws
the heat sink.
d. Tighten the screws.

A. CPU
D. Heat Sink
• 6 Screws
2 - 14 Removing and Installing a Processor
(Figure 10a), pay careful attention to the pin alignment, it will fit only one way (DO NOT
A
(Figure 10c) from the heat sink.
C
as indicated in
D
10d) * Note: Make sure that the size of the screwdriver is below 4mm. when removing or tighting screw
a.
A
b.
B
Lock
towards the lock symbol (Figure
B
Figure 10d.
, , , , &
1 2 3 4 5 6
c.
d.
3
2
1
4
6
10b).
(the order as indicated on the label and
(page 2 -
C
C
D
Note:
Tighten the screws
in the order as indi-
5
cated on the label.
,
5
6).