Table of Contents
Advertisement
7. How do I reset my device to factory default settings?
a. To reset the device back to its factory default settings, press and hold the
WPS/Reset button for over 10 seconds, until the white power LED begins to
flash. Please wait a few minutes for the product to restart. When the device
restarts, all settings will be reset. Default settings are displayed on the product
label on the bottom of the device, as shown below:
Router Login
Username/Password This is the default username and password to
Wi-Fi Network
Name
MAC
PIN CODE
Enter this URL in a web browser to run iQ Setup or
configure advanced settings. You must be
connected to the device by Wi-Fi or Ethernet
cable.
access the browser based configuration interface
when you go to the "Router Login" URL (above).
This is the default Wi-Fi network name for the
device. Search for this name (SSID) and connect to
it in order to access the "Router Login" URL
(above).
A MAC address is unique to every device and is
used for identification within a network. Your
device's unique MAC address is displayed here.
This is your device's PIN code for Wi-Fi Protected
Setup (WPS).
10
Advertisement
Table of Contents
