World Time - Casio Edifice EQB-700 Operation Manual

World Time

Q1
The time for a World Time City is not
correct.
The summer time start date and time, end date
and time, or other rules were changed by
authorities.
Hand Movement and
Indications
Q1
Why can't I perform any button
operations while high-speed hand
movement is in progress?
Button operations are disabled while high-
speed hand movement is in progress after a
watch setting is changed, etc. Wait until the
hands stop moving before performing button
operations.
Q2
The second hand is jumping at two-
second intervals.
Battery power is low. Keep the watch exposed
to light until it recharges sufficiently.
Charging the Watch
l
Q3
All hands are stopped at 12 o'clock
and buttons do not work.
The battery is dead. Keep the watch exposed
to light until the battery recharges sufficiently.
Charging the Watch
l
Q4
The hands suddenly start moving at
high speed.
This is due to one of the reasons below, and
does not indicate malfunction. Simply wait
until normal hand movement resumes.
The watch is recovering from a power
●
saving state.
Power Saving
l
Establish a connection with the phone and
●
correct the time setting.
Auto Time Adjustment
l
Operation Guide 5467
Q5
Hands are stopped and buttons do
not work.
The watch is in the charge recovery mode.
Wait until the recovery process is complete
(for about 15 minutes). The watch will recover
more quickly if you place it in a brightly lit
location.
Q6
Hands and the day indicator are out
of alignment.
Strong magnetism or impact may cause the
hands of the watch to go out of alignment. Use
CASIO WATCH+ to correct hand alignment.
Correcting Hand Alignment
l
Q7
The time setting is correct, but the
day indicator is between days.
The day is in the process of changing. For
information about how the day changes, see
the section below.
Hands and the Day Indicator
l
Crown Operations
Q1
Nothing happens when I rotate the
crown.
Leaving the crown pulled out for more than
nine minutes without performing any
operation will automatically disable crown
operation. Push the crown back in to its normal
position and then pull it out again.
Using the Crown
l
Q2
Crown operation does not work.
Crown operation is disabled while high-speed
hand movement is in progress after a watch
setting is changed, etc. Wait until the hands
stop moving before performing crown
operations.
Charging
Q1
The watch does not work even
though it is exposed to light.
The watch stops operating whenever the
battery goes dead. Keep the watch exposed
to light until it recharges sufficiently.
Solar Charging
l
15