By-Pass Tray - Ricoh B121 Service Manual

3.3.10 BY-PASS TRAY

[B]
1. Right rear cover (
2. Open the right door (
3. Release the by-pass tray cable from the clamps (see [C] on the preceding
page) and disconnect the connector (5-pin connector with colored wires).
4. Cable holder [A] (B123 only)
5. Front-side clip ring [B]
6. Front-side pin [C]
NOTE: You can push the pin from behind the right door.
7. Front-side tray holder arm [D]
8. Remove the rear-side clip ring, pin, and tray holder arm in the same manner.
9. By-pass tray [E]
SM
EXTERIOR COVERS & OPERATION PANEL
[C]
[D]
B121R948.WMF
3.3.8)
3.3.9).
3-9
[A]
[E]
B121 Series/B259 Series
B121R907.WMF