Audiovox Prestige Platinum 128-4638D Installation Manual
Audiovox Prestige Platinum 128-4638D Installation Manual

Audiovox Prestige Platinum 128-4638D Installation Manual

Audiovox car security system installation manual
Hide thumbs Also See for Prestige Platinum 128-4638D:
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be
certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Dip Switch Selectable Features :
Switch Number
Dip Switch 1
Dip Switch 2
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver's door pin switch in order to
begin the passive arming sequence.
RF Programmable Features :
Feature Selection
First
Second
Third
Fourth
Fifth
Sixth
To program these selectable features;
Action
Turn ignition on
Flip valet switch on then off 3 times
Within 3 seconds, turn ignition Off
First
Then On
Press transmitter button 1 to change
Second
Flip valet switch on then off
Press tranmitter button 1 to change
Third
Flip valet switch on then off
Press transmitter button 1 to change
Fourth
Flip valet switch on then off
Press transmitter button 1 to change
Fifth
Flip valet switch on then off
Press transmitter button 1 to change
Sixth
Flip valet switch on then off
Press transmitter button 1 to change
Flip valet switch on then off
Turn ignition key off
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the program-
ming will be terminated.
SELECTABLE FEATURES
ON Position
Custom Code Override
Voltage Sense
1 Chirp
1 Second Door Locks
Auto Lock On
Auto Unlock On
Headlight Output On
Passive Door Locks
Passive Arming
or
or
or
or
or
or
or
OFF Position
Valet Switch Override
Hardwire
2 Chirps
3.5 Second Door Locks
Auto Lock Off
Auto Unlock Off
Headlight Output Off
Active Door Locks
Active Arming
System Response
No response
1 Chirp - LED 1 flash
Short chirp, then long chirp
1 chirp = 1 second door locks
2 chirps = 3.5 second door locks
2 chirps = auto locks off
1 chirp = auto locks on
2 chirps = auto unlock off
1 chirp = auto unlock on
1 chirp = headlight output on
2 chirps = headlight output off
1 chirp = passive locks
2 chirps = active locks
1 chirp = passive arming
2 chirps = active arming
Exit program mode
Exit program mode
Page 1
Model APS 600
Installation Manual
Factory Default
Custom Code Override
Voltage Sense
Default
1 Second
Auto Lock Off
Auto Unlock Off
Headlight On
Passive Locks
Active Arming

Advertisement

Table of Contents
loading

Summary of Contents for Audiovox Prestige Platinum 128-4638D

  • Page 1 Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual. Dip Switch Selectable Features : Switch Number ON Position...
  • Page 2 INSTALLATION OF MAJOR COMPONENTS Control Module : Select a mounitng location inside the passenger compartment ( up behind the dash ), and secure using the two screws provided. The control module can also be secured in place using cable ties. Do not mount the control module in the engine compartment, as it is not waterproof.
  • Page 3: Wiring The System

    Note : This is a normally closed starter cut arrangement, and when power is removed from the security system, the starter disable feature will not operate, allowing the vehicle to start. Audiovox does not recommend using the Orange wire to interrupt anything but the start- ing circuit of the vehicle.
  • Page 4 2 Dark Green w/ White Trace Wires : ENTRY ILLUMINATION The dark green w/ white trace wires provide the entry lighting, and flash the vehicle’s dome light while the alarm is sounding. These are NO ( normally open ) and COM ( common ) contacts of an on board, 10 Amp maximum relay.
  • Page 5 Note : This is a normally opened starter cut arrangement, and when power is removed from the security system, the starter disable feature will remain operational, and the vehicle will not start. Audiovox does not recommend using the Orange w/ White trace wire to interrupt anything but the starting circuit of the vehicle.
  • Page 6 2 Pin White Connector : DASH MOUNTED L.E.D. Route the red and blue wires in the 2 pin white connector from the L.E.D. to the control module, and plug it into the mating white connector on the side of the module. 4 Pin White Connector : SHOCK SENSOR Route the red, black, blue, and green wires in the 4 pin white connector from the shock sensor to the control module, and plug one end into the shock sensor, and the other end into the mating white connec-...
  • Page 7: Completing The Installation

    Operation : Take a few moments to check off the appropriate option boxes in the owner’s manual, and to fully explain the operation of the system to your customer. Audiovox Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 Page 7 128-4638D...
  • Page 8: Shock Sensor

    SIREN BLACK GREEN w/WHITE ENTRY ILLUMINATION Connect to +12 VDC Battery for Positive Switched Dome Light or Chassis Ground for Negative Switched Dome Light EXISTING DOOR PIN SWITCH DOME LIGHT GREEN w/WHITE GROUND SOURCE Connect to Vehicle's Chassis TRUNK RELEASE Connect to +12 VDC Battery for Positive Switched Trunk Release Chassis Ground for Negative...
  • Page 9: Horn Output

    CHANNEL 4 Negative Latching Output for Optional Remote Start or Window Roll-Up LT. BLUE GREEN w/BLACK CHANNEL 3 Negative Latching Output for Optional Remote Start or Window Roll-Up BLACK w/WHITE HORN OUTPUT Connect to Low Current Negative Wire from Horn Switch GROUND OUTPUT DISARMED when...
  • Page 10 Remarque: On peut choisir une des deux méthodes de dérivation manuelle: soit par l'interrupteur de sevice voiturier, soit par le code personnalisé. Assurez-vous de bien indiquer quelle est la méthode employée en cochant la case appropriée à l dernière page du manuel d'utilisation. Fonctions sélectionnées par commutateur (DIP switches): Numéro de commutateur Position Marche [ON]...
  • Page 11 INSTALLATION DES COMPOSANTS PRINCIPAUX MODULE DE COMMANDE: Choisir un emplacement de fixation à l’intérieur du compartiment passager (en haut sous le tableau de bord) et serrer à l’aide des deux vis fournies. On peut également fixer le module de commande en place à l’aide de serre-câbles.
  • Page 12: Câblage Du Système

    Audiovox ne recommande l’usage du fil orange que pour la coupure du circuit de démarreur du véhicule et rien d’autre.
  • Page 13 DEUX FILS VERT FONCÉ À RUBANS BLANCS: ÉCLAIRAGE INTÉRIEUR Les fils vert foncé à rubans blancs alimentent l’éclairage intérieur et font clignoter le plafonnier pendant que l’alarme sonore retentit. Il s’agit des contacts normalement ouverts (NO) et communs (COM) d’un relais de bord de 10 ampères maximum.
  • Page 14 Audiovox ne recommande l’usage du fil orange à ruban blanc que pour la coupure du circuit de démarreur du véhicule et rien d’autre.
  • Page 15 Les fils orange et bleu à ligne blanche doivent être connectés à l'alimentation de tension continue positive de 12 volts d'une batterie munie d'un fusible. Se reporter au Supplément de schémas de câblage de verrouillage de portes AUDIOVOX pour consulter les circuits de connection de ces fils aux divers circuits de verrouillage disponibles dans les véhicules actuellement sur le marché.
  • Page 16: Finition De L'installation

    Ceci empêche les fils de tomber sur des surfaces chaudes ou des surfaces mobiles tranchantes du véhicule, ce qui évite tout dommage. FONCTIONNEMENT: Prendre quelques instants pour cocher les cases d'option dans le manuel d'utilisation, et pour expliquer complètement le fonctionnement du système au client. Audiovox Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-4638D Page 16...
  • Page 17 SIRENE NOIR VERT / BLANC ÉCLAIRAGE DE L'ENTRÉE Connecter à la batterie +12 VCC pour commutation positive du plafonnier Mise à la masse au châssis pour commutation négative du plafonnier CONTACTEUR LAMPE DE DE PORTE EXISTANT PLAFONNIER VERT/BLANC SOURCE DE MISE À LA MASSE Relier au châssis du véhicule OUVERTURE DU COFFRE À...
  • Page 18 CANAL 4 Sortie à enclenchement négatif pour remontage de glace ou démarrage à distance en option BLEU CLAIR CANAL 3 Sortie à enclenchement VERT/NOIR négatif pour remontage de glace ou démarrage à distance en option NOIR/BLANC SORTIE D'AVERTISSEUR Connecter au fil négatif à courant basse tension provenant de l'interrupteuir d'avertisseur ORANGE/NOIR...
  • Page 19 Nota: El método de anulación manual puede seleccionarse para funcionar desde el interruptor valet o con un código especial. Ponga una marca de control para indicar el método usado en el casillero que hay en la última página del manual del propietario.
  • Page 20 INSTALACIÓN DE LOS COMPONENTES PRINCIPALES MÓDULO DE CONTROL: Seleccione un lugar de instalación dentro del compartimiento de pasajeros (arriba detrás del tablero), y fijelo usando los dos tornillos incluidos. El módulo de control puede también fijarse en su lugar empleando ligaduras de alambre. El módulo de control no debe instalarse en el compartimiento del motor puesto que no es a prueba de agua.
  • Page 21: Cableado Del Sistema

    Nota: Por lo general se trata de un corte cerrado del arrancador y cuando se deja de alimentar el sistema de seguridad, la función de desactivación del arrancador no funciona y se puede arrancar el vehículo. Audiovox no recomienda usar el cable anaranjado solamente para interrumpir el circuito de arranque del vehículo.
  • Page 22 2 CABLES VERDE OSCURO CON MARCAS BLANCAS: ILUMINACIÓN DE ACCESO O ENTRADA. Los cables verde oscuro con marcas blancas proporcionan la luz de entrada y hacen destellar la luz de techo del vehículo cuando suena la alarma. Son contactos NO (normalmente abiertos) y COM (comunes) de un relé...
  • Page 23 Nota: Por lo general se trata de un corte abierto del arrancador y cuando se deja de alimentar el sistema de seguridad, la función de desactivación del arrancador sigue funcionando y no se puede arrancar el vehículo. Audiovox no recomienda usar el cable anaranjado con marcas blancas para interrumpir el circuito de arranque del vehículo.
  • Page 24 Los alambres anaranjado y azul con franja blanca deben conectarse a una fuente de batería de +12 VDC con fusibles. Refiérase al Suplemento de Alambrado de Cierres de Puertas de AUDIOVOX para la conexión correcta de estos alambres en los diversos circuitos de cierre disponibles en los vehículos actuales.
  • Page 25 OPERACIÓN: Tome unos momentos para verificar las casillas de opción adecuadas en el manual del propietario y para explicar bien el funcionamiento del sistema a su cliente. Audiovox Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-4638D Page 25...
  • Page 26 SIRENA NEGRO (-) A TIERRA DEL CHASIS DEL VEHICULO VERDE/BLANCO ILUMINACIÓN DE ENTRADA Conectar a la Batería de +12 V. CD para Luz de Techo de Conmutación Positiva Conectar a Tierra en el Chasís para Luz de Techo de Conmutación Negativa CONMUTADOR DE CLAVIJA DE PUERTA LAMPARA...
  • Page 27 CANAL 4 Salida de Cerradura Negativa para Opciones de Encender el Motor o Cerrar y Abrir los Vidrios por Control Remoto AZUL CLARO CANAL 3 VERDE/ Salida de Cerradura NEGRO Negativa para Opciones de Encender el Motor o Cerrar y Abrir los Vidrios por Control Remoto NEGRO/BLANCO SALIDA DE LA BOCINA...

This manual is also suitable for:

Prestige platinum aps 600

Table of Contents