Ribao CS-311S Operation Manual page 11

CS-311S Operation Manual V1.2
NOTES：The above steps are used for setting the BATCH number.
If you need to set the BATCH, you need to turn on the BATCH
function in system. Under main interface, press
the BATCH on/off. When BATCH function is on, there is a B shown
at the left corner; if there is no B, it means the BATCH function is
turned off.
When one channel Batch No. setting is finished, you can come
back to channel number selection interface by pressing SET key and
then repeat the above number setting way to set batch number for
other target channels. After all settings are finished, press ESC key to
quit from BATCH submenu to come back into main menu interface.
When the machine reaches set Batch number, the LCD display will
show as follows:
MIX- COUNT
B
For example, if you batch 10pcs for 2.00, when the quantity
reaches 10pcs for 2.00, the machine will stop and show "2.00 BATCH
OK"and flash. At this moment, you need to clear the drawer for 2.00
and press CLR to clear the message, otherwise other key functions are
not workable.
(2) VALUE
Under VALUE interface，press
channel. Under one channel, press SET key to fix the VALUE setting
STOP
VALUE:
COUNT:
2.00 BATCH OK
VALUE SET
CHANNEL: 1
VALUE: 2.00
Page 11 of 17
key to turn on
20.00
10
F:
key to switch the
，
2