TP-Link TL-WR802N Quick Installation Manual page 14

English
Access Point Mode
1. Set your wireless parameters. If desired, you may change your
Wireless Network Name, Wireless Security Mode, or Password.
Click Next and then Reboot.
Note: After the rebooting, reconnect to the network according to Instant
Wireless Connection.
Repeater/Client Mode
The examples illustrated below are from Repeater Mode, but the procedure is similar
for Client Mode.
1. Click Survey button to find the available wireless networks.
Then select the SSID of your target network and click Connect.
Working Mode Operation Mode Wireless Setting Network Setting
AP Mode setting:
Wireless Network Name(SSID):
Region:
Warning: Ensure you select a correct country to conform local law.
Incorrect settings may cause interference.
Channel:
Wireless Security Mode:
If you choose No Security mode, the wireless stations will be able to connect
the AP without encryption. It is recommened strongly that you choose one of
following options to enable security.
Working Mode Operation Mode Wireless Setting Network Setting
Repaeter Mode setting:
:
Wireless Name of Root AP
MAC Address of Root AP:
Region:
Warning:
WDS Mode:
Wireless Security Mode:
Wireless Password:
TP-LINK_C5FC
United States
Auto
No Security
Back Next
Survey
United States
Ensure you select a correct country to conform local law.
Incorrect settings may cause interference.
Auto
Most Secure (WPA/WPA2-PSK
All security settings, for example the wireless password should match the Root AP.
You can enter ASCII or Hexadecimal characters. For Hexadecimal, the length
should be between 8 and 64 characters; for ASCII, the length should be
between 8 and 63 characters. For good security it should be of ample length
and should not be a commonly known pharse.
Back Next
12
Finish
(Also called the SSID)
Finish
(Also called the SSID)