Table of Contents
Advertisement
3.4 HOW TO INSTALL
SCREWDRIVER(+, -), RULER, KNIFE, HAMMER, PENCIL, LEVEL
PREPARATION OF CHASSIS
1. Before installing the room air conditioner, please
install the knob. (If it is not fixed on the unit.)
2. Remove the screws which fasten the cabinet at
both sides and at the back.
3. Slide the unit from the cabinet by gripping the base
pan handle and pulling forward while
bracing the cabinet.
4. Remove the white styrofoam block from the
compressor. (Only AWC126CGAA0)
5. Slide the air conditioner into the case.
Reinstall the 2 screws removed earlier on each side
of the case.
CAUTION: The power cord must be connected to an independent
circuit. The green wire must be grounded.
6. Stuff the foam between the top of the unit and the
wall to prevent air and insects from getting into the
room.
—13—
Shipping
Screws
White
styrofoam
block
Advertisement
Table of Contents
