Table of Contents
Advertisement
3.4 HOW TO INSTALL
SUGGESTED TOOL REQUIREMENTS
SCREWDRIVER(-, -), RULLER, KNIFE, HAMMER, PENCIL, LEVEL
PREPARATION OF CHASSIS
1. Before installing the room air conditioner, please
install the knob. (If it is not fixed on the unit.)
2. Remove the screws which fasten the cabinet at
both sides and at the back.
3. Slide the unit from the cabinet by gripping the base
pan handle and pulling forward while
bracing the cabinet.
4. Slide the air conditioner into the case.
Reinstall the 2 screws removed earlier on each side
of the case.
CAUTION: The power cord must be connected to an independent
circuit. The green wire must be grounded.
Screw
Figure 25
Power Cord
Figure 26
5. Stuff the foam between the top of the unit and the
wall to prevent air and insects from getting into the
room.
6. Attach the front grille to the case by inserting the
tabs on the grille into the slots on the front of the
case. Push the grille in until it snaps into place.
When you detach the front grille from the case,
push the grille to your right side and pull it toward
you.
7. Lift the inlet grill and secure the front grille with a
screw. Lower the inlet grille into place.
(In case of some models, you can secure the front grille
from the right side or lower side.)
Figure 22
Figure 23
Figure 24
Figure 27
Figure 29
—18—
=
Shipping
6
Screws
Advertisement
Table of Contents
