Error Messages - Pioneer AVIC-F70BT Operation Manual

Appendix
Appendix
Symptom
The smartphone was not
charged.

Error messages

When problems occur with this product, an error message appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
record the error message and contact your dealer or your nearest Pioneer service centre.
Common
Message
AMP Error
TEMP
Product overheat, For protec-
tion the System will shut
down automatically in 1 min-
ute. Re-cycle the ignition to
restart the product If this mes-
sage keeps showing, please
contact your dealer or local
service centre.
Positioning is not possible
due to hardware error. Please
consult your dealer or local
authorised service centre.
No GPS antenna. Check con-
nection.
GPS antenna problem de-
tected. Contact dealer or ser-
vice center.
Calibration will start, but may
be inaccurate without speed
pulse.
Sensor error. Please contact
your dealer or Pioneer Service
Center.
186
Engb
Cause
Charging stopped because the tem-
perature of the smartphone rose
due to prolonged use of the smart-
phone during charging.
More battery power was consumed
than was gained from charging.
Cause
This product fails to operate or the
speaker connection is incorrect; the
protective circuit is activated.
The temperature of this product is
outside the normal operating range.
The temperature is too high for this
product to operate.
The location display is not possible
due to hardware failure.
GPS reception is lost.
GPS aerial lead is short-circuited.
The speed pulse sensor is not con-
nected correctly.
An error has occurred with the sen-
sor.
Action
Disconnect the smartphone from the cable,
and wait until the smartphone cools down.
This problem may be resolved by stopping
any unnecessary services on the smartphone.
Action
Check the speaker connection. If the mes-
sage fails to disappear even after the engine
is switched off/on, contact your dealer or an
authorised Pioneer Service Station for assis-
tance.
Wait until this product returns to a tempera-
ture within the normal operating limits.
Follow the instructions displayed on the
screen. If this does not solve the problem,
contact your dealer or an authorised Pioneer
Station for assistance.
Contact your dealer or an authorised Pioneer
Station for assistance.
Check the aerial connection. If the message
fails to disappear even after the engine is
switched off/on, contact your dealer or an
authorised Pioneer Station for assistance.
Contact your dealer or an authorised Pioneer
Station for assistance.
Contact your dealer or an authorised Pioneer
Station for assistance.
Contact your dealer or an authorised Pioneer
Station for assistance.