Led Descriptions - Cisco 7200 VXR User Manual

Field-Replaceable Units

LED Descriptions

The I/O controller faceplate contains LEDs that indicate system and port status;
two additional LEDs indicate the status of the Flash Disk or Flash memory cards
installed in either PC Card slot. A CPU reset button is located next to the IO
POWER OK LED or next to the auxiliary port on the I/O controller faceplate. The
CPU reset button resets the entire system.
Caution To prevent system errors and problems, use the CPU reset button
only at the direction of your service representative.
Table 1-15 lists LEDs common to all models of I/O controllers and describes their
functions.
LEDs are either on or off. The LED state (on or off), not the color,
Note
determines the status of connection. However, most LEDs are green
when on, with the exception of the IO POWER OK LED, which is
orange when in the on state.
Table 1-15 I/O Controller LEDs
LED Color
ENABLED Green
IO POWER Orange
OK
Slot 0 Green
Slot 1
Cisco 7200 VXR Installation and Configuration Guide
1-42
Function
Indicates that the network processing engine or network services engine
and the I/O controller are enabled for operation by the system; however, it
does not mean that the Fast Ethernet port on the I/O controller is functional
or enabled. This LED goes on during a successful router boot and remains
on during normal operation of the router.
Indicates that the I/O controller is on and receiving DC power from the
router midplane. This LED comes on during a successful router boot and
remains on during normal operation of the router.
These LEDs indicate which PC Card slot is in use by coming on when
either slot is being accessed by the system. These LEDs remain off during
normal operation of the router.
Chapter 1 Cisco 7200 VXR Product Overview
78-5469-03