ZyXEL Communications NBG6716 User Manual page 16

Figure 4 Front Panel
WPS
Button
The following table describes the LEDs and the WPS button.
Table 1 Front panel LEDs and WPS button
LED STATUS
WPS Button Press this button for 1 second to set up a wireless connection via WiFi Protected Setup
with another WPS-enabled client. You must press the WPS button on the client side within
120 seconds for a successful connection. See
page 56
Power On
Off
WAN On
Blinking
Off
Internet On
Blinking
Off
WLAN 2.4/5G On
Blinking
Off
LAN 1-4 On
Blinking
Off
USB 1-2 On
Blinking
Off
Chapter 1 Introduction
Power
Internet
WLAN 5G
WAN
LAN 1-4
DESCRIPTION
for more information on WPS.
The NBG6716 is receiving power and functioning properly.
The NBG6716 is not receiving power.
The NBG6716's WAN connection is ready.
The NBG6716 is sending/receiving data through the WAN with a 1000Mbps
transmission rate.
The WAN connection is not ready, or has failed.
The NBG6716 has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the
connection is up.
The NBG6716 is sending or receiving IP traffic.
The NBG6716 does not have an IP connection.
The NBG6716 is ready, but is not sending/receiving data through the 5G
wireless LAN.
The NBG6716 is sending/receiving data through the 5G wireless LAN.
The NBG6716 is negotiating a WPS connection with a wireless client.
The wireless LAN is not ready or has failed.
The NBG6716's LAN connection is ready.
The NBG6716 is sending/receiving data through the LAN with a 1000Mbps
transmission rate.
The LAN connection is not ready, or has failed.
The NBG6716 has a USB device installed.
The NBG6716 is transmitting and/or receiving data from routers through an
installed USB device.
There is no USB device connected to the NBG6716.
NBG6716 User's Guide
16
WLAN 2.4G
USB 1-2
WPS
Section 1.6 on page 14 and Section 8.2 on