Monogram ZET2S Owner's Manual page 27

How to
Double oven display shown.
delay the
start of
cleaning
You can set the oven to delay the start of cleaning,
clean for a selected length of time and turn off
automatically.
NOTE: Before beginning, make sure the clock shows the
correct time of day.
NOTE: The Mini-Knob must be pushed for the self-clean
cycle to be set to start at the time of day entered.
The oven is now set to turn on at the time of day you set
and clean for the set amount of clean time.
If your oven is connected to a 208V electrical supply, we
recommend that you set your clean time for 5 hours.
After a
You may notice some white ash in the oven. Wipe it up
with a damp cloth after the oven cools.
clean cycle
If white spots remain, remove them with warm sudsy
water and rinse thoroughly with a vinegar and water
mixture. These deposits are usually a salt residue that
cannot be removed by the clean cycle.
Push to
select
Turn the Oven Mode knob to CLEAN.
Turn the Oven Temperature knob to CLEAN.
The oven will be set to clean for its normal clean time
of 5 hours. (If a clean time less than 5 hours is needed,
turn the Mini-Knob to the clean time desired.) Push to
enter it.
You can change the clean time to any time between
3 and 5 hours, in 15 minute increments, depending on
the amount of soil in your oven.
NOTE: The Mini-Knob must be pushed for the self-
clean cycle to be set.
Push the DELAY START button. The current time of day
will flash in the display.
On double oven models, push the DELAY
START button once to set the upper oven and
twice to set the lower oven.
Turn the Mini-Knob to select and push it to enter the
time of day you want the oven to turn on and start
cleaning.
Self-Cleaning Oven
Oven Mode knob
Mini-Knob
Turn to select
Push to enter
If LOCKED flashes in the display, the self-clean cycle has
been selected but the door is not closed. Close the oven
door.
To check the start time, push the DELAY START button. To
change it, turn and push the Mini-Knob.
The display will show START TIME. When the start time is
reached, the oven will turn on automatically.
The display will show CLEAN and the clean time remaining.
As the oven heats to the clean temperature, the door will
lock automatically. The LOCKED light will turn on.
The display will show the clean time remaining.
It will not be possible to open the oven door until the
temperature drops below the lock temperature and the
LOCKED light goes off.
To stop a clean cycle, turn the Mode Selector and the
Temperature knobs to OFF. When the LOCKED light goes
off, indicating the oven has cooled below the locking
temperature, you will be able to open the door.
NOTE: On double oven models, you can set a delay clean
in both ovens at the same time. Turn the Oven Mode knob
and the Temperature knob of the second oven to CLEAN.
The second oven set will automatically delay the start of
cleaning until the end of the first oven's clean cycle.
If the oven is not clean after one clean cycle, repeat
the cycle.
You cannot set the oven for cooking until the oven is cool
enough for the door to unlock.
Wall Oven
Temperature knob
After the clean cycle is complete and the oven has
cooled, END will show in the display and the LOCKED
light will turn off. Turn the Mode Selector and the
Temperature knobs to OFF.
27