Cleaning And Maintenance - Siemens ER95351HK Installation And Operation Instruction Manual

Cleaning and maintenance

please make sure that
burner heads and caps
have been installed
correctly.
Once the appliance is cool, use a sponge to clean it with
soap and water. When cleaning, do not dismantle the safety
device or sealed parts of the hob.
Do not use a granular cleanser or steel wool to clean the
faceplate. These may cause scratches on the surface of
the hob. Please use soft gauze and soap suds to clean and
maintain the hob faceplate.
After each use, clean the surface of the respective burner
parts once they have cooled down. If any bits are left
(overcooked food, drops of grease etc.), however few, they
will become stuck to the surface and more difficult to remove
later. The holes and grooves must be clean for the flame to
ignite properly.
It is recommended to clean the caps of the gas hob at least
once a month.
When you are using the hob, you may find that the flame is
not uniform or some burner openings have no flame. In this
hole
case, please turn off the hob, wait unit it cool down before
taking off the cap and use an iron slice and steel needle to
remove the dirt and carbon blocking the burner openings. As
shown in the picture, please make sure that burner heads
and caps have been installed correctly.
The movement of some pans may leave metal residue on
the pan supports.
If the pan supports are fitted with rubber rests, ensure that
these are also cleaned. The rests may come loose and the
pan support may scratch the hob.
Always dry the burner and pan supports completely. Water
droplets or damp patches on the hob at the start of cooking
may damage the enamel. Do not wash the cap directly with
water as the bubbles may temporarily block the fire holes.
After cleaning and drying the burner, make sure the burner
covers are correctly placed on the burner flame diffuser.
Warning: When dismantling the cap parts prior to cleaning
and reassembling them after cleaning, take care when
touching the ignition needle as it is made of ceramic material
which can be easily damaged. Once the surface of the
products are cleaned, please ensure they are put back
correctly, otherwise the electronic device may not operate
correctly.
22