The Drain Hose At The Siphon Is Blocked; Filter In The Water Supply Blocked - Siemens WS12K261HK Instructions Manual

Cleaning and maintenance
en
Carefully unscrew the pump cover.
6.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Reinsert and screw on the pump
7.
cover. Handle should be vertical.
Close the service flap. If required,
8.
engage disengaged service flap
beforehand.
To prevent unused detergent
Note:
from flowing into the outlet during the
next wash: Pour 1 litre of water into
dispenser II and start the 0 p Spin/
Empty programme: (if only a drained
cycle is required: set rpm (spin speed)
to - - -).
The drain hose at the siphon
is blocked
Turn the programme selector to Off.
1.
Remove the mains plug.
Loosen hose clip and carefully
2.
remove drainage hose.
Residual water may run out.
Clean the drain hose and siphon
3.
connecting piece.
Reattach the drain hose and secure
4.
the connection point using the hose
clamp.
24
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any programme (except
2.
0 p Spin/Empty).
Select ! Start/Reload. Leave
3.
programme for approx. 40 s.
Turn the programme selector to Off.
4.
Remove the mains plug.
Clean the filter on the tap:
5.
Disconnect the hose from the water
tap.
Clean the filter with a small brush.
Clean the filter on the back of the
6.
appliance:
Remove the hose from the rear of
the appliance.
Take out the filter with pliers and
clean it.
Connect the hose and check for
7.
leaks.