Channel Master DVR+ User Manual page 18

Programming your remote using Code Entry
To program the remote with a 4-digit numerical code, use the steps below.
Note: Where several codes are listed for a manufacturer, it may be necessary to repeat the
sequence below with each code until the correct one is found.
1
2
3
Hold down
VOL - on DVR+ remote
for 2 sec until TV
button flashes twice.
The table on the following pages contains the manufacturer codes for programming
the remote control to operate your TV. If your TV brand is not listed or if the codes
listed for it do not work, the DVR+ remote may not be able to control your TV. In
some cases, codes may operate some, but not ALL the buttons shown in this guide.
:: Getting Started
12
Hold down both the CH+ and VOL- keys simultaneously for at least two
seconds. The blue TV button LED gives two slow flashes to indicate
successful entry into the setup mode.
Using the numbered keys (keypad) on the remote control, enter the
4-digit code for your TV manufacturer within 30 seconds. The blue TV
button LED flashes for each entry.
Note: Remote codes for TVs are listed on pages 13-15.
After the fourth digit entry, the blue TV button LED gives two slow
flashes to indicate that the code has been successfully programmed.
In the event of an error, the blue TV button LED gives four rapid flashes.
If this occurs, then you will need to begin the code entry process again.
When you successfully program a code that turns your TV on and
controls its volume and inputs, write down this code in the spaces
provided.
Remote Code:
CH + and
Enter remote code listed
for your TV brand. TV
button flashes twice.
Remote Codes
Repeat until code works
with your TV. Write down
this code.