Related Commands - HP 5500 SI Troubleshooting Manual

2. Verify that the ACL is configured correctly:
a. Execute the display acl command.
b. If the ACL is configured incorrectly, reconfigure it.
3. If the problem persists, contact HP Support.
ACL used in a packet filter
To resolve the problem when the ACL is used in a packet filter:
1. Verify that the packet filter is configured correctly:
a. Execute the display packet-filter command.
b. If there are any configuration errors, reconfigure the packet filter.
2. Verify that the ACL is configured correctly:
a. Execute the display acl command.
b. If there are any configuration errors, reconfigure the ACL.
3. If the problem persists, contact HP Support.

Related commands

This section lists the commands that you might use for troubleshooting ACLs.
Command
display acl resource
display packet-filter
display qos policy control-plane
display qos policy global
display qos policy interface
display qos vlan-policy
display traffic classifier user-defined
display traffic behavior user-defined
Description
Displays information about hardware resources for ACL
applications.
Displays whether an ACL has been successfully applied to an
interface for packet filtering.
Displays information about the QoS policies applied to the
specified control plane.
Displays information about global QoS policies.
Displays information about the QoS policies applied to an
interface or to all interfaces.
Displays information about QoS policies applied to VLANs.
Displays traffic class configurations.
Displays traffic behavior configurations.
3