Introduction
This document provides troubleshooting information for HP 5500 EI and 5500 SI switches. This document
is not specific to any software versions.
Troubleshooting ACL
This section provides troubleshooting information for common problems with ACLs.
ACL application failure with an error message
Symptom
The system fails to apply a packet filter or ACL-based classifiers in a QoS policy to the hardware. It also
displays this message: "Reason: Not enough hardware resource."
Solution
To resolve this problem:
1.
Execute the display acl resource command, and then check the Remaining field for ACL resources
insufficiency.
If this field displays 0, the ACL hardware resources are exhausted.
2.
To free hardware resources, remove unused packet filters or ACL-based classifiers from QoS
policies.
3.
If the problem persists, contact HP Support.
ACL application failure without an error message
Symptom
The system applies a packet filter or a QoS policy that contains ACLs to the hardware. However, the ACL
does not take effect.
1