Time Remaining; Once The Program Has Finished - Asko D5536 FI Operating Instructions Manual

you use the same program. An exception is the Delayed start
option.
High temperature
Activate this option for improved dishwashing results. The ma-
chine then uses a higher temperature for the main wash.
If you want to use the lower temperature, press again so that the
field under the button turns off.
You can vary the temperature as shown below:
Heavy: 60 °C / 70 °C
Normal: 48 °C / 65 °C
Daily: 60 °C / 65 °C
Quick: 30 °C / 60 °C
Delicate: 40 °C / 50 °C
Eco: 53 °C / 60 °C
Long dry
The higher temperature in the final rinse and longer drying im-
proves the drying result if you activate the Long dry option. This
causes a slight increase in energy consumption. This option can
be used with all programs except Rinse & Hold.
If you want a program with Short dry, press again so that the field
under the button turns off.
Delayed start
When you select Delayed start, the dishwasher will start 1–24
hours after you press the Start/Stop button.
1 Press the button once to activate Delayed start. Press the
button several times – or hold it in – to set the desired number
of hours.
2 Press Start/Stop and the dishwasher counts down 1 hour at
a time and starts after the selected delay.
Press and hold Start/Stop for three seconds if you want to cancel
the Delayed start option.
NOTE!
Remember to press the Start/Stop button to start the program.
Start the dishwasher
Press and hold Start/Stop until the display shows
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last program run.

Time remaining

Once you have selected a program and options, the display indi-
cates how long the program took the last time it was used. The
remaining time is updated after the water for the final rinse has
been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the ambi-
ent temperature and other factors.
NOTE!
During the first run of each program, the remaining time dis-
played can be slightly misleading, as the dishwasher is estimat-
ing the time. When you run the program a second time, the
dishwasher will calculate the remaining time based on the
previous duration of the program.
Stopping or changing a program
If you want to change program after starting the dishwasher,
open the door then press and hold Start/Stop for three seconds.
Add more detergent if the lid of the detergent dispenser has
opened. Then choose a new program, press Start/Stop and close
the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door and the dishwasher continues the program.
If the dishwasher is turned off using
the On/Left-on mode button or due
to a power failure
If the dishwashing program was not finished, the interrupted
program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or
the door is open for more than 2 minutes.

Once the program has finished

Once the program has finished and the door is opened "End"
appears on the display.
At the end of the program, you will hear a short beep. Chapter
Settings describes how to change this function.
Once the dishwasher has finished, it only uses standby power.
Shut off the water tap after every use.
(the door
Drying
For additional drying the door should be opened 35 mm upon
completion of the drying cycle. For more information, see page
15 in the chapter Technical information.
7