Effect Control - Yamaha TNR-e Quick Manual

Effect Control

Tapping the [EFFECT] button calls up the Effect control display.
Touch or drag the XY Pad to turn the active Effect on.
The correspondence between each Effect type's parameter and the location on the XY Pad is shown below.
FILTER
Low Pass High Pass
Filter Filter
Cutoff
NOISE
C.Freq, M.Ratio, M.Index, LPF Freq
Touching two points on the XY Pad (for example, with the index fingers on your left and right hands) cycles continuously
between the two values/parameters.
The speed of the cycle can be specified by the [MOTION] button.
When the lock switch is set to on, the effect continues even after you release your fingers from the display; when the lock switch
is set to off, the effect stops when you release your fingers.
TNR-e Quick Guide
Lock switch
DECIMATOR
Decimation
LOOPER
4th 16th 64th
2nd 8th 32nd
Loop Length
[MOTION] button
XY Pad
Tap this to activate the Master Effect.
Tapping both the left and right buttons at the
same time activates the two Master Effects
simultaneously.
Sliding the button calls up the Effect list and
lets you select the Master Effect type.
DELAY
8th 16th 32nd 64th
Delay Time
ISOLATOR
Low Mid High
Solo Solo Solo
128th
Low Mid High
Mute Mute Mute
Effect Control
FLANGER
128th
LFO Freq
16