If The Following Appear On Your Display - Panasonic KX-TG5230AL Operating Instructions Manual

TG5230AL.fm Page 66 Friday, June 11, 2004 5:31 PM

If the Following Appear on Your Display...

Display message
Error!!
System is busy.
Please try again
later.
Phone book full
---Incomplete---
Tom Jones
0987654321
Phone book full
(The name/number is
an example.)
---Incomplete---
Tom Jones
0555654321
(The name/number is
an example.)
Phone book
No items stored
Denied
66
Cause & Remedy
• When you tried to register or deregister the handset,
the handset and base unit could not link for some
reason, such as interference from electrical
appliances. Move the handset and base unit away
from any electrical appliances and try again.
• If more than one handset is in use, you may not be
able to register/deregister. Try again later.
• Another handset tried to send phone book items to
you but copying stopped. Have the other handset
user re-send the items to you (p. 39, 40).
• If more than one other user is using the handset and/
or base unit, such as conducting outside/intercom
calls, you may not be able to use the handset. Try
again later.
• The handset has lost communication with the base
unit. Walk closer to the base unit and try again.
• When you tried to store an item in the phone book,
the phone book memory was full. Press [OFF] to exit
programming mode. To erase other items from the
phone book, see page 38.
• When the displayed item was sent to the destination
handset, the phone book memory was full and
copying stopped. If you tried to send all of the items,
the item displayed with "Incomplete" and items
after it have not been copied to the destination
handset. Press [OFF] to exit (p. 39, 40). To erase
items from the destination handset phone book, see
page 38. You can copy all of the items again or copy
the items which have not been copied one by one
(p. 39, 40).
• The destination handset is out of area.
• The destination handset user may have pressed
[C] or [s].
• Your phone book is empty. No items were copied to
the destination unit.
• The Room Monitor feature is turned off on the
destination handset or base unit and cannot be
monitored (p. 49).
• The called handset was on the base unit. The
handset must be off the base unit to be monitored.