Error Messages - Panasonic KX-TG4381NZ Operating Instructions Manual

Error messages

If the unit detects a problem, one of the following messages is shown on the display.
Display message
Busy
or
System is busy.
Please try again
later.
Check tel line
Dial locked
Don't use this
battery.
Error!!
Insert battery
Invalid
No link to base.
Reconnect AC
adaptor.
Phonebook full
Store VM access# L You have not stored the voice mail access number.
*1 KX-TG4382/KX-TG4392
*2 KX-TG4391/KX-TG4392
Cause/solution
L The called handset
L Another handset is in use and the system is busy. Try
*1
again later.
L The handset you are using is too far from the base unit.
Move closer and try again.
L The handset's registration may have been cancelled.
Re-register the handset (page 48).
L The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 12).
L Dial lock is turned on. To turn it off, see page 19.
L A wrong type of batteries such as Alkaline or
Manganese was inserted. Use only the rechargeable Ni-
MH batteries noted on page 5, 13.
L The handset's registration has failed. Move the handset
and base unit away from all electrical appliances and try
again.
L The entered password was wrong in programming dial
lock. Enter the correct password.
L The handset was placed on the base unit or charger
without batteries. Insert the batteries properly (page 13).
L There is no handset registered to the base unit matching
the handset number you entered.
L The handset is not registered to the base unit. Register
the handset (page 48).
L The handset has lost communication with the base unit.
Move closer to the base unit and try again.
L Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset's registration may have been cancelled.
Re-register the handset (page 48).
L The phonebook memory is full. Erase unnecessary
entries (page 21).
Store the number (page 37).
Useful Information
*1 *2
or base unit is in use.
*1
43