Winding The Bobbin; Bobbin Winding - Pfaff C1100 Pro Owner's Manual

WINDING THE BOBBIN

Note: Due to the independent bobbin winder motor, you can wind the bobbin during sewing.
Follow the steps for "Winding The Bobbin" except place the thread for the bobbin through
the thread guide opening not in use being careful not to tangle thread.

Bobbin winding

a
b
1
2
6
1. Align the groove (a) in the bobbin with the spring
(b) on the bobbin winder shaft, and then place
the empty bobbin on the bobbin winder shaft.
2. Place the spool of thread and spool cap onto
the spool pin. For smaller spools of thread,
use the small spool cap.
Spool cap should be close in size to the thread
spool, however should not be any smaller. If the
spool cap is smaller than thread spool, thread
may get caught in the slit on end of spool and
cause damage.
Note: If the thread spool does have a slit
on the end, it is recommended to place
this end of the spool toward the bottom,
so it doesn't get caught while sewing or
bobbin winding.
22
GETTING READY
4
3
2
5
1
11
8
7
9