Panasonic NV-GS60GC Operating Instructions Manual page 88

LSQT1135ENG.book 88 ページ ２００６年１２月２２日 金曜日 午後１０時２分
5: The movie camera cannot be operated
though powered up.
The movie camera does not operate
normally.
• The movie camera cannot be operated unless
you open the LCD monitor or extend the
viewfinder.
• Remove the cassette and then press the
[RESET] button. ( ) If normal conditions are
-89-
not restored yet, turn off the power. Then,
about 1 minute later, turn on the power again.
6: The cassette cannot be removed.
• Does the status indicator comes on when
opening the cassette cover? (
that the battery and the AC adaptor are
properly connected. (
-55-
• Is the battery in use discharged? Charge the
battery and remove the cassette.
• Close the cassette cover completely, and fully
open it again. ( )
-60-
7: No operation other than cassette removal
can be performed.
• Has condensation occurred? Wait until the
condensation indication disappears. (
Recording
1: Recording does not start although power is
supplied to the movie camera and the
cassette is correctly inserted.
• Is the accidental erasure prevention slider on
the cassette open? If it is open (set to [SAVE]),
recording cannot be performed. (
• Is the tape wound to the end? Insert a new
cassette.
• Is the recording mode set? When in the
playback mode, recording cannot be
performed. ( )
-65-
• Has condensation occurred? No operation
other than cassette removal can be performed
when condensation occurs. Wait until the
condensation indication disappears. (
• Is the cassette cover open? If the cover is
open, the movie camera may not operate
normally. Close the cassette cover. (
2: The screen has changed suddenly.
• Has the demonstration started? In the Tape
Recording mode, if you set [DEMO MODE] >>
[ON] without inserting a cassette, the
demonstration starts. For normal use, set this
function to [OFF]. ( )
-84-
3: A cassette cannot be inserted.
• Has condensation occurred? Wait until the
condensation indication disappears.
88
LSQT1135
Others
4: Auto focus function does not work.
• Is manual focus mode selected? If auto focus
• There are some recording subjects and
• Is the colour night view function set? When the
Indications
) Make sure
-56-
1: A sentence is displayed in red in the screen
)
• Read the contents and respond to them. (
2: The remaining tape time indication
• The remaining tape time indication may
)
-90-
3: The remaining tape time Indication does not
• If scenes of less than 15 seconds are
• In some cases, the remaining tape time
)
-60-
4: A function indication such as mode
• If you set [SETUP] >> [DISPLAY] >> [OFF],
)
-90-
)
-60-
mode is selected, focus is automatically
adjusted.
surroundings for which the auto focus does not
operate correctly. ( ) If so, use the manual
-95-
focus mode to adjust the focus. (
colour night view function is working, focusing
shifts into the manual mode.
centre.
disappears.
disappear temporarily during frame-by-frame
playback or other operation. If you continue
ordinary recording or playback, the indication is
restored.
match the actual remaining tape time.
continuously recorded, the remaining tape time
cannot be correctly displayed.
indication may show remaining tape time that is
2 to 3 minutes shorter than the actual
remaining tape time.
indication, remaining tape time indication,
or time code indication is not shown.
indications other than the tape running
condition, warning, and date indications
disappear.
)
-75-
)
-86-