Table of Contents
Advertisement
[PLEASE RE-CONNECT THE PRINTER.]
This message will be displayed if you
change the mode dial to print mode [
while this unit and the PC are connected. If
a printer is connected, change the mode to
a mode other than [
check that no data is being transferred.
([ACCESS] appears on the LCD monitor of
this unit while data is being transferred.)
[USB MODE CHANGED. PLEASE
REMOVE THE USB CABLE.]
This message will be displayed if you
change the mode dial to a mode other than
print mode [
] while this unit and the
printer are connected.
Set the mode dial to [
disconnect the USB cable. If printing, stop
the printing and then disconnect the USB
cable.
Troubleshooting
If you return the menu settings to the initial
settings at the time of purchase, the
condition may improve.
Select [RESET] in the [SETUP] menu.
(P20)
∫ Battery and power source
1: The camera cannot be operated even
when it is turned on.
• Is the battery inserted correctly?
– Check the direction of the battery. (P13)
• Is the battery sufficiently charged?
– Use a battery that has been
sufficiently charged.
2: The LCD monitor turns off while the
camera is turned on.
• Is power save mode (P19) or economy
mode (P19) activated?
– Press the shutter button halfway to
cancel these modes.
• Is the battery exhausted?
– Use a battery that has been
sufficiently charged.
3: The camera turns off immediately
]
] mode and then
∫ Recording
1: The picture cannot be recorded.
] again and then
2: The recorded picture is whitish.
3: The recorded picture is too bright or
4: 2 or 3 pictures are taken at one time.
5: The subject is not focused properly.
after it is turned on.
• Is the battery charge insufficient to
operate the camera?
– Use a battery that has been
sufficiently charged.
– If you leave the camera on, the
battery will be exhausted. Turn the
camera off frequently by using power
save mode (P19) etc.
• Is the mode dial correctly set?
• Is there any memory remaining on the
built-in memory or the card?
– Before recording, delete some
pictures. (P30)
The lens is dirty.
• The picture can become whitish if there
is dirt e.g. fingerprints on the lens. If the
lens is dirty, turn on the camera, eject
the lens barrel (P9) and gently wipe the
lens surface with a soft dry cloth.
dark.
• Check that the exposure is correctly
compensated. (P40)
• Is auto bracket (P41) or burst mode
set? (P65)
• The focus range varies depending on
the recording mode.
Rotate the mode dial to set the proper
mode for the distance to the subject.
• Is the subject beyond the focus range of
the camera? (P23, 43)
• Have you taken a picture with jitter?
Others
101
VQT1B99
Advertisement
Table of Contents
