Table of Contents
Advertisement
TG2421AL_2422AL(e).book Page 32 Tuesday, March 15, 2005 6:29 PM
Programmable Settings
Display options
Handset LCD contrast
You can adjust the handset display
contrast. There are 6 levels. The default
setting is level 3.
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press {>}.
3
Scroll to "LCD contrast" by pressing
{V} or {^}, then press {>}.
4
Press {V} or {^} repeatedly to select
the desired setting.
5
Press {Save}, then press {OFF}.
32
Telephone settings
Recall time
The recall time depends on your telephone
exchange or host PBX.
You can select: "90ms" (milliseconds),
"100ms" (default), "110ms", "250ms",
"300ms", "400ms", "600ms", or "700ms".
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press {>}.
3
Scroll to "Set tel line" by pressing
{V} or {^}, then press {>}.
4
Scroll to "Set recall time" by
pressing {V} or {^}, then press {>}.
5
Press {V} or {^} repeatedly to select
the desired setting.
6
Press {Save}, then press {OFF}.
Note:
L You can access Telstra's "EASY CALL"
service by having the recall time set at
100 ms, and then follow Telstra's "EASY
CALL" instructions to operate this
service.
L If the unit is connected via a PBX, certain
PBX functions (call transferring, etc.)
may not work correctly. Consult your
PBX supplier for the correct setting.
Line mode
The line mode is preset to "B" and
generally should not be adjusted. If "Line
in use" on the handset is not displayed
properly, the line mode selection is
incorrect. Set line mode to "A".
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press {>}.
Advertisement
Table of Contents
