Jeep COMPASS 2015 Owner's Manual page 228

226 UNDERSTANDING YOUR INSTRUMENT PANEL
NOTE: If the vehicle is equipped with the optional
Electronic Vehicle Information Center (EVIC) in the in-
strument cluster, all warnings including "Door Ajar", and
"Gate Ajar" will only be displayed in the EVIC display.
Refer to "Electronic Vehicle Information Center — If
Equipped" for additional information.
gASCAP
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
"gASCAP" message will display in the odometer display
area. Tighten the fuel filler cap properly and push the
TRIP ODOMETER button to turn off the message. If the
problem continues, the message will appear the next time
the vehicle is started.
A loose, improperly installed, or damaged fuel filler cap
may also turn on the Malfunction Indicator Light (MIL).
LoW tirE
When tire pressure is low, the odometer display will
toggle between LoW and tirE for three cycles.
HOTOIL
When this message is displayed, there is a engine over-
temperature condition. When this condition occurs, the
"HOTOIL" message will be displayed in the odometer
along with a chime.
Refer to "If Your Engine Overheats" under in "What To
Do In Emergencies" for further information.
CHANgE OIL Message
Your vehicle is equipped with an engine oil change
indicator system. The "CHANgE OIL" message will flash
in the instrument cluster odometer for approximately 12
seconds after a single chime has sounded to indicate the
next scheduled oil change interval. The engine oil change
indicator system is duty-cycle based, which means the